myFordFocus.com
myFordFocus.com HomeFrequently Asked QuestionsHow-To LibraryMessage Boards2002 SVTOwner's GuidePhoto GalleryZX3Racing.com

myFordFocus.com How-To Do-It-Yourself Instructions
(Based on 2000-2004 Zetec & SPI Model Focus')

All information contained here and on subsequent pages are subject to the myFordFocus.com Terms of Use Policy, which basically states that myFordFocus.com IS NOT responsible for anything you do to your car... Please read it! :)



Rear Drum Painting

Before
Rear Brake Drum Paint

During
Rear Brake Drum Paint

After
Rear Brake Drum Paint


Have your rear drums have lost thier original factory paint and look dull and maybe even have rust spots. Here is a good how-to.

Tools required:

  • 1 can of high heat engine paint or brake caliper paint.
  • 1 can of brake cleaner.
  • Wire brush.
  • Mild soapy water.
  • Shop rag(s).
  • Newspaper or something for masking off area you don't want the spray paint to hit...
  • Masking tape.
  • Wheel grease.

Note: The engine paint is overkill @ 1200 degrees, but it's what Napa had so I bought it. I have a can of 600 degree yellow for my front brake calipers that I'll do next.

Time to complete: .5 - 1 hour

Cost: Approx. $10

Instructions:

  1. Jack up the rear of the car, obviously on the side you are working on.
  2. Remove the wheel.
  3. If your drum has rust spots, use a wire brush to remove the rust spots.
  4. Clean the drum with the brake cleaner.
  5. Wash down the drum with the mild soapy water to remove any residue.
  6. Let dry.
  7. Mask off any area you don't want the spray paint to get on, like the fenders...
  8. Paint the drum with 3-4 light coats of the paint, allowing each coat to dry for several minutes.
  9. Let dry for 15-30 minutes.
  10. Take a good look and be amazed at the job you did
  11. Add a small amount of wheel grease to your wheel hub, to prevent your wheel from seizing to the hub.
  12. Replace your wheel.
  13. Take another long look at the new paint job

Copyright 2001 MyFordFocus.com
Terms of Use